What is starter?

Why we put intercooler, its effect on second stage?

Explain sacrificial anode in cooler?

What are the tools required for cutting gasket, what type of gaskets you have on board and material of it?

Explain cylinder head tightening procedure and hydraulic jack principle?

How to do piston ring calibration?

Tappet clearance indication on flywheel, if unit 3 and 5 is on tdc then how to find which one have firing condition?

How to remove piston and safety, bottom end brg clearance ?

Cloover liffing reason and why is called its name, cuases ?

Explain m/e, a/e, boiler specification, how to change over boiler to egb?

How to make collision b/h water tight after passing a pipe?

What is tumble home and piston slap?

Where synchronous motor is used on board ships?

How do you measure the fatigue resistance of a particular material?

What is galvanometer and where it is used?

Why the neutral pin is larger in diameter in a plug point?

Where zener diode is used?

How to change cooler division plate?

What is a tachometer, how does it works?

What is the difference between safety valve and relief valve?

How to order gland packing?

How you will specify feeler gauge?

What is center griders?

Can main engine be run at full load with fresh water generator stopped?

How to take bottom end bearing clearance in generator? How to change gland in pump?

What is the safety device in emergency fire pump between the volute casing and discharge line?

What is the full name on RTA?

What is the abbreviation for MC-C in m/e type?

How purifier rpm is more than motor rpm?

Maneuvering is going on and suddenly main air compressor cooler is leaking, what will be your step?