How the axial thrust is accommodated in generator?

Why to blowthrough the generator/main engine prior starting?

What all is given in muster list?

How you will measure the length of the chain cable went inside water while putting the anchor?

What all checks to be made in bottom end bearing bolts?

How container crane works?

What is spcv?

Explain overhauling of unloader?

What is fitted bolt & where it used?

At the time of scavenge trunk temp high alarm whether we should drain scavenge trunk?

What is servo reversing motor, where it is used?

How signal transmission takes place from bridge to ecr and to govnr?

Explain air comp v/v overhauling?

What are air comp v/v parts?

How you will cutoff one unit in fuel pump?

What lubrication on ref and air compressor?

How to change leafs of telescopic feelergauge?

What is telescopic feelergauge?

Explain main bearing removal?

What is insulation resistance, how it is tested onboard?

How to increase powerfactor?

What is the pump room lighting arrangement?

How many seals are there in turbocharger?

How turbocharger is getting lubricated?

If purifier overflowing what will you do?

Explain purifier manual desludging?

What is opening pressure of exhaust v/v?

What is closing pressure of exhaust v/v?

Explain exhaust v/v working principle?

At what position and how will you take the bottom end bearing clearance in generator and why?