3 years agoComment at
HOW WILL YOU DETERMINE WHETHER YOU HAVE TO VENTILATE THE HOLD OR NOT ? I will the check the oxygen content of the hold ,if it is low i will ventilate the hold ...
3 years agoUp voted comment at
Which is stress calculation equipment onboard ? i said its loadicator,he said ok what does it show i said SF and BM curves,then he asked how much is allowed,i said its mentioned in stability booklet permissible limits in different ...
3 years agoUp voted comment at
How many hours before entering a seca you will ask engine room to changeover the fuel oil ? i told as per annex 6,sufficient time before so that previous fuel fully drains from the system, he insisted on amount of hours,when i was helpless i told him 2 to 3 hours on my ship.then he said ...
3 years agoUp voted comment at
Where is lifeboat capacity mentioned on boat ? i said on the hull
3 years agofollowed
Deepesh Vishnoi 3 years agoUp voted comment at
Lifeboat is loaded with full complement , you hv to take another person inside , action ? in no case you can allow him to enter inside,he has to hold grab lines or some other thing outside of boat.
3 years agoUp voted comment at
Flash pt. It is the minimum temperature at which enough vapours are produced to bring about a momentary flash when a source of ignition is introduced.
There are two methods for finding flash ...
3 years agoUp voted comment at
how will You find position if your equipments all failed ? I would fix my position using visual bearings.
(as it is not stated whether the ship is sailing near the coast or in open sea)
